Live Handmade,  Buy Handmade!

Step 1
Cut 80cm sliver beading wire in 18 gauges. String one bead to the center of the wire..

Step 2
Bend two ends of the wire against the beads to point downward.

Step 3
Put the bead against the ring mandrel on your desired size and then begin to wrap the wire to your desired amount of loops.

Step 4
Wrap both ends of the wire from the bottom of the center bead to your desired amount of wraps. Make the two ends point back in the direction it started, show in step 3.

Step 5
Take the ring out of the ring mandrel and hold the center of the bead, wrap one of the wire ends around the ring band with three wraps.

Step 6
Use side cutting plier to cut the tail end of the wire.

Step 7
Do the same to wrap the other end of the wire. Use chain nose plier to trim both ends.

Step 8
Place the ring back onto the ring mandrel. Taking a rubber mallet to hammer the back of the ring band, so the wires can lay flat.

Step 9
Congratulations! You have completed a wire wrapped ring.